How WAN ports work on the dual-use Cisco Meraki MX ports
Last updated: October 2026
On several mid-range Meraki MX models (MX75, MX85, MX95, MX105), the WAN ports are paired. Each pair consists of one SFP (or SFP+) port and one copper RJ45 port. Only one of the ports in the pair can be active at any one time — either SFP or copper, but not both.
How pairing works
If an SFP module is inserted (and detected at boot), the partner copper port is disabled.
If a cable is connected to the copper port, the partner SFP is disabled.
You cannot use both the SFP and the copper port of the same pair simultaneously.
This is by design. The firmware treats each pair as a single logical WAN interface that can be presented as either fibre or copper. You can log into the local management page of the MX to specify which port should be active.
Practical implications
You can mix media: SFP on WAN 1 and copper on WAN 2 (or the reverse), because they belong to different pairs.
You cannot have SFP and copper active on the same WAN pair.
SFP detection typically occurs at boot. Hot-inserting an SFP after the appliance is running often requires a reboot for the port to become active.
Models that use this behaviour
MX75, MX85, MX95 and MX105 follow the paired-port model. Lower models such as the MX67/MX68 use simpler dedicated or convertible copper ports without SFP pairing.
When planning a fibre WAN, order the correct SFP (or SFP+) and plan to use the SFP side of the pair. The copper side of that pair will not be available for a second circuit.
FAQ
Can I use both the SFP and copper port in the same pair?
No. Inserting an SFP disables the partner copper port, and vice versa.
Can I mix fibre and copper on different WANs?
Yes. Different pairs are independent, so WAN 1 can be SFP and WAN 2 can be copper.
Do I need to reboot after inserting an SFP?
Usually yes. SFP detection happens at boot; hot-insert often requires a reboot.
Which models have this paired-port behaviour?
MX75, MX85, MX95 and MX105.
Megatron Technology is an authorised Cisco Networking Partner in Singapore. We can confirm port behaviour for a specific MX model and supply the correct optics.
Frequently asked questions
Can I use both the SFP and copper port in a pair?
No. On paired WAN ports only one of the pair is active — either SFP or copper, not both.
Which models have paired WAN ports?
Several mid-range models including MX75, MX85, MX95 and MX105.
Megatron Technology (est. 1990, UEN 199002644W) is an authorised Cisco Networking Partner and Managed Services Provider in Singapore. Contact: +65 6346 2001 · info@megatron.com.sg.