Can Cisco Meraki MX support 3 WAN ports?
Last updated: October 2026
Some Meraki MX models can use a third WAN link, but only as a backup. It is not a third active uplink for load balancing or policy-based routing.
Supported models and requirements
Models: MX75, MX85, MX95, MX105
Firmware: MX 18.2 or later
Feature name: MultiWAN Backup Uplink (2 active + 1 backup)
On these models the third (or fourth physical) port becomes a backup-only uplink. It stays idle until both primary WAN links are down. It cannot be set as a primary or secondary active link.
Important caveats
Enabling MultiWAN disables the normal SFP/copper pairing behaviour. All WAN ports become independent.
On MX85/95/105, one of the physical ports is disabled once MultiWAN is enabled.
Not all NAT features (port forwards, 1:1 NAT, 1:Many NAT) are supported on the backup uplink.
IPv6 is not supported on the backup uplink.
Secure Connect / Secure Access tunnels continue to use only WAN 1 and WAN 2.
When to use the third WAN
You have a third circuit (often a 4G/5G backup) that should only activate when both primary links fail.
You want automatic failover to a low-cost or low-capacity link without consuming an active slot.
When not to use it
You need three active links for load balancing or application-based steering.
You require full NAT features or IPv6 on the third link.
Your model is older than the MX75–MX105 range, or you are not on MX 18.2+.
For true three-active-WAN designs, most organisations still use a FortiGate or another platform that supports multiple active SD-WAN members with full SLA monitoring.
FAQ
Can a Meraki MX load-balance across three WAN links?
No. The third link on supported models is backup-only. It activates only when both primary links are down.
Which models support a third WAN?
MX75, MX85, MX95 and MX105, running MX 18.2 or later.
What happens when I enable MultiWAN?
Port pairing is disabled, some physical ports may become unusable, and certain NAT features are limited on the backup link.
Is the third WAN suitable for primary traffic?
No. It is designed purely as failover.
Megatron Technology is an authorised Cisco Networking Partner in Singapore. We can check whether a specific MX model and firmware can use the MultiWAN backup feature for your circuits.
Frequently asked questions
Can a Meraki MX load-balance across three WAN links?
No. A third WAN link is backup only. It is not a third active uplink for load balancing or policy routing.
Which models support a third WAN?
Check the model datasheet. Support is limited and the third link is failover only.
Megatron Technology (est. 1990, UEN 199002644W) is an authorised Cisco Networking Partner and Managed Services Provider in Singapore. Contact: +65 6346 2001 · info@megatron.com.sg.